a big plea for information!!!

Anything else ya ride!
Post Reply
User avatar
verntowers
Posts: 139
Joined: Wed Oct 28, 2009 7:04 pm
Rides:: honda 70ish
Location: nowhere

a big plea for information!!!

Post by verntowers » Mon Jul 21, 2014 2:00 pm

hello all, i have obviously had a very senior moment and have bought myself a honda sh50 for a cheap run about whilst i fully restore my c70 `margret`but the problem is that it is painfully slow at the moment and seems to slow down as the more i go along .i carnt find any good infomation as how to speed it up??? if at all this can be done??? i bought it cos it was a honda it seems it is the rogue honda:) :oops: :lol:

User avatar
zippy
Posts: 1736
Joined: Wed Jan 26, 2011 3:35 pm
Rides:: 1982‪ Honda CT50JC Motra 1972 Honda ST70 1972 Honda Z50A K3
Location: Wirral

Re: a big plea for information!!!

Post by zippy » Mon Jul 21, 2014 2:40 pm

you could clean the carb and check the tank for dirt.

Do your valves, prob never been done.

As for all 4 strokes, bar the c50? can not really be made to go faster. They are normally tuned for what they are intended for.

User avatar
verntowers
Posts: 139
Joined: Wed Oct 28, 2009 7:04 pm
Rides:: honda 70ish
Location: nowhere

Re: a big plea for information!!!

Post by verntowers » Mon Jul 21, 2014 3:47 pm

have done carb and tank buddy, it is a two stroke though so does not have valves i think?

User avatar
Alan CF
Posts: 6757
Joined: Mon May 09, 2011 6:10 pm
Rides:: CUB RACING small cc engine rebuilds crank repairs
Location: CHESTERFIELD

Re: a big plea for information!!!

Post by Alan CF » Mon Jul 21, 2014 5:42 pm

i believe its a two stroke, so your first port of call is the exhaust, it could be blocked. after that depending on how long its sat around for or mileage, is the crankcase seals.

davebike
Posts: 2903
Joined: Thu Dec 01, 2011 4:31 pm
Rides:: C90G(12v) NC750X dct msx125 Grom
Location: LONDON SE20 /Blindly Heath Surrey

Re: a big plea for information!!!

Post by davebike » Wed Jul 23, 2014 7:52 am

Alan !! Sh50 is a 4 stroke !!

There not that tunable and as a restricted moped that is intended
you can fit a 70cc top and re - jet the carb but I wish you luck doing it legally I spent ages as a trader trying to do this by the book and DVLA were useless !!

User avatar
verntowers
Posts: 139
Joined: Wed Oct 28, 2009 7:04 pm
Rides:: honda 70ish
Location: nowhere

Re: a big plea for information!!!

Post by verntowers » Wed Jul 23, 2014 9:35 am

alan is right it is a two stroke

davebike
Posts: 2903
Joined: Thu Dec 01, 2011 4:31 pm
Rides:: C90G(12v) NC750X dct msx125 Grom
Location: LONDON SE20 /Blindly Heath Surrey

Re: a big plea for information!!!

Post by davebike » Wed Jul 23, 2014 12:08 pm

That is one old Sh then Fowlers Honda parts lists goes back to 193/4 and shown a 4 stroke engine for all SH50 !

User avatar
Alan CF
Posts: 6757
Joined: Mon May 09, 2011 6:10 pm
Rides:: CUB RACING small cc engine rebuilds crank repairs
Location: CHESTERFIELD

Re: a big plea for information!!!

Post by Alan CF » Wed Jul 23, 2014 7:03 pm

SH50 Info, spec sheet,

They were well known for coking up the exhausts, and also snapping the exhaust studs when trying to remove it. :(

Take the exhaust off and place your lips on to the gasket end, there should be not restriction when blowing down it.

http://www.motorbikespecs.net/index.dyn ... make=Honda

User avatar
wightegi
Posts: 9718
Joined: Tue Sep 01, 2009 7:23 pm
Rides:: 12v 1988 e start C90,Royal Enfield Interceptor 650
Location: Isle of Wight

Re: a big plea for information!!!

Post by wightegi » Wed Jul 23, 2014 8:29 pm

50ccNL used to list performance exhaust for them ..italian engine ,also known as the scoopy ,city express and sky.

User avatar
Alan CF
Posts: 6757
Joined: Mon May 09, 2011 6:10 pm
Rides:: CUB RACING small cc engine rebuilds crank repairs
Location: CHESTERFIELD

Re: a big plea for information!!!

Post by Alan CF » Sat Aug 02, 2014 10:41 am

how did you get on with the bike. have you sorted it. :?:

Post Reply