hi from cov
hi from cov
hi all, paul from coventry with a recently restored ss50, working on a project at the min to run a c90 top end on a ss50 gearbox, will keep all informed.
- Newtsalad
- Admin & site janitor.
- Posts: 17626
- Joined: Fri May 01, 2009 8:30 am
- Rides:: XL1200c, Cali III, C125,GS750,XV535,XL350,BN125,C90's,C200's,CT200,Little Cub's
- Location: Essex boy loose in Suffolk!
Re: hi from cov
Hello Paul, welcome aboard the c90club! Look forward to reading about your project!
- Boo
- Posts: 8439
- Joined: Mon May 04, 2009 9:53 pm
- Rides:: Elephant Grey 1967 CM90 based 'bitsa'.
- Location: East Lancashire.
- Contact:
Re: hi from cov
Sounds a good project Paul!
If you haven't bought any C90 bits yet, you'll need to get them from the 12 volt model, as the 6v C90 was built on a completely different set of castings than the 50 and nowt fits.
If you're already on with it, you'll know this already, so my apologies!
If you haven't bought any C90 bits yet, you'll need to get them from the 12 volt model, as the 6v C90 was built on a completely different set of castings than the 50 and nowt fits.
If you're already on with it, you'll know this already, so my apologies!
-
- Posts: 51
- Joined: Thu Aug 02, 2012 9:17 pm
- Rides:: Cub 70
Re: hi from cov
hi paul im from coventry too, hows the project going?
- Newtsalad
- Admin & site janitor.
- Posts: 17626
- Joined: Fri May 01, 2009 8:30 am
- Rides:: XL1200c, Cali III, C125,GS750,XV535,XL350,BN125,C90's,C200's,CT200,Little Cub's
- Location: Essex boy loose in Suffolk!
Re: hi from cov
Paul is no longer a member/no longer visits the site. Go to the map top of New to the forum to find members near you.